Designing electronics for deep-space exploration involves navigating some of the most unforgiving environments in the solar system. Among these, the region surrounding Jupiter stands out due to its exceptionally high levels of cosmic radiation and trapped energetic particles. For mission planners and hardware designers, ensuring that onboard systems can survive this punishing onslaught is a paramount challenge. Recently, senior electronics engineer Janos Nagy detailed how an engineering team successfully analyzed and resolved a critical in-flight power supply unit issue tied to radiation-induced component degradation on a Jupiter-bound spacecraft. The core of the issue centers on a specialized power supply unit engineered to provide regulated voltages to the spacecraft’s vital onboard sensors. Operating under a nominal 28 V input voltage, the power supply is responsible for stepping down and converting power into stable +5 V, +3.3 V, and −5 V output rails. These regulated voltages are essential for satisfying the precise power requirements of sensitive scientific instruments meant to study the Jovian environment. Read Also: Synopsys Unveils AgentEngineer to Accelerate Silicon-to-System Design with Autonomous AI Agents Gigabyte Confirms New Intel Processors for LGA 1700 Motherboards Coming in Early 2027 At the heart of the power conversion architecture are two IRHNJ57024 N-channel MOSFETs, which correspond to the radiation-hardened JANSR2N7480U3 devices utilized in spaceflight hardware. The power supply’s primary conversion section relies on a pulse-width modulation (PWM) controller that drives these two N-channel MOSFETs via a specialized gate-drive transformer. This configuration controls the energy delivered to a main power transformer, designated as T1501, which ultimately supplies power to the downstream load. A key design feature of this stage is the galvanic isolation maintained between the PWM controller and the switching stage, protecting sensitive input circuitry against any potential failures occurring within the heavy-duty power stage. To maximize overall efficiency, the circuitry incorporates energy recovery mechanisms. During the turn-off interval of the MOSFETs, energy that would otherwise be wasted—specifically that stored in the leakage inductances of transformer T1501—is successfully recovered and returned to the DC-link buffer capacitors. Furthermore, the system maintains strict electrical separation between the power ground and the PWM ground. By galvanically isolating the power ground from the digital and processing grounds, the design shields the delicate PWM control circuitry from harmful voltage spikes and electrical noise generated by high-current switching events in the power stage. Managing transient noise is a constant battle in high-power space electronics. The rapid switching of the power MOSFETs can easily generate high-amplitude voltage spikes and transient noise across the power ground due to parasitic inductances and fast di/dt currents. To mitigate this, the engineering team optimized specialized snubbers based on empirical measurements, effectively suppressing the disruptive effects of leakage inductance and parasitic capacitance. Regulation is maintained through the PWM controller’s voltage-feedback and current-sense inputs, utilizing a feedback signal proportional to the total output current to enforce precise voltage regulation and reliable current limiting. However, even the most rigorous pre-flight testing cannot always anticipate every variable encountered once a mission is underway. Following the spacecraft’s launch, the engineering team conducted additional testing on the N-channel MOSFETs. The results uncovered an unexpected vulnerability: the specific manufacturing lot of the MOSFETs integrated into the design exhibited high sensitivity to high-dose-rate radiation. Degradation in the devices was observed when the radiation dose rate exceeded 50 rad(Si)/s. This discovery was particularly alarming because the components had already been fully qualified for a total ionizing dose of up to 100 krad(Si), highlighting a critical gap between total dose qualification and high-dose-rate behavior. Exposure to this high-dose-rate radiation caused a severe reduction in the MOSFET threshold voltage, dropping Vth by approximately 45%. According to the official component datasheets, the normal gate threshold voltage falls within a range of 2.0 V to 4.0 V. With a nominal pre-irradiation threshold of 2.0 V, a staggering 45% reduction would degrade Vth down to approximately 1.1 V. This drastic shift raised immediate concerns regarding how the change would impact the fundamental switching behavior, stability, and long-term reliability of the power supply circuit during the remainder of the deep-space mission. To determine the severity of the threat, the engineering team launched a thorough investigation using advanced PSpice circuit simulations. In these simulations, the MOSFET threshold voltage parameter was systematically varied over a wide range, pushed down far below the calculated degradation level to an extreme low of 0.5 V. The simulation results provided a crucial sigh of relief for the mission team. They demonstrated conclusively that the circuit continued to operate correctly and without failure, even when subjected to significantly degraded Vth values. Because the MOSFETs in this specific design function strictly as high-speed switching devices rather than linear amplifiers, the substantial reduction in the gate threshold voltage did not impede proper circuit operation or destabilize the power delivery rails. The simulations confirmed that the +5 V, +3.3 V, and −5 V supply voltages remained entirely nominal. The successful resolution of this in-flight anomaly underscores the critical importance of combining meticulous circuit design, advanced simulation tools, and thorough post-launch verification in modern space hardware engineering. Janos Nagy, whose career in scientific instrumentation, embedded systems, power electronics, and space hardware spans decades at institutions including the KFKI Institute for Particle and Nuclear Physics and the Centre for Energy Research, demonstrated how analytical foresight can safeguard vital missions venturing into the most hostile regions of space. Post navigation Revamping Your Workspace: How to Upgrade Your PC Desk Setup When Major Hardware is Out of Reach